logo

EN
nan4
News
Emulsion by Design: From Droplet Structure to Skin Feel
2026-11-19
20

Developing a lightweight oil-in-water lotion is not simply a matter of reaching a target viscosity. The oil droplets need to remain dispersed, but excessive thickening can take the formula away from its intended texture. Rather than asking how thick the lotion needs to be, start with two questions: What keeps this emulsion stable, and does that structure suit the intended feel during application?

Emulsion stability depends on more than viscosity

When screening conventional emulsifiers, the oil phase’s required hydrophilic–lipophilic balance (required HLB) is a useful starting point, followed by testing in the actual formulation. The composition of the oil phase is more informative than oil polarity alone. Blending higher- and lower-HLB emulsifiers is one way to optimize the oil–water interface, but the result depends on the emulsifier combination, its ratio, and the formulation—not simply on the difference between their HLB values.

When the interfacial film is not the main issue, a different approach may be needed. Anionic emulsifiers can give oil droplets a negative surface charge, creating electrostatic repulsion that helps limit flocculation. The effect depends in part on the electrolyte conditions in the water phase. Increasing the viscosity of the continuous water phase or forming a polymer network can restrict droplet movement and help delay creaming, but it does not necessarily make droplets less likely to coalesce. The interfacial film, interactions between droplets, and continuous-phase rheology are distinct aspects of formulation design. Not every formula needs all three to be reinforced.

For lightweight lotions, evaluate emulsification and thickening separately

Inverse-emulsion polymers offer a way to design around the continuous phase. When the ingredient is dispersed in water, it is the ingredient’s carrier emulsion—not the finished lotion—that undergoes inversion. The released polymer expands in the water phase and can form a network that restricts droplet movement while modifying viscosity and texture.

In Reachin’s internal formulation tests, RenatuCare® 625 provided emulsifying support with a comparatively modest increase in viscosity. For lotions designed to feel lightweight, this points to a practical selection criterion: assess how a material affects oil dispersion and formula viscosity separately, rather than treating higher viscosity as evidence of better emulsification.

Sunscreen lotion case: adding the polymer after initial emulsification

In a Reachin sunscreen lotion formulated for a fresh, lightweight feel, the water and oil phases were prepared separately and homogenized to form the initial emulsion. Repoly® EG was then added, followed by a second homogenization step. The existing emulsifier blend was retained; Repoly® EG was added after initial emulsification rather than used to replace that blend.

The case shows why order of addition belongs in the formulation discussion. First identify what needs to change—the interface, droplet movement, or texture. Then decide which material to use and when to add it, and assess both stability and skin feel in the complete formulation.